Transfer Documentation

This screen is required if Transfer is a primary goal on Basic Program Info screen.

Transfer GE Worksheet

Complete and attach the Transfer GE Worksheet.​

  • If you are submitting an ADT, this worksheet duplicates information required by the TMC template; however, the worksheet is easier to use because it has some auto-calculated fields. While you can skip this worksheet for ADTs (just check that it is attached anyway), it is recommended to fill out the worksheet first to help you with the TMC template.​
  • If you are submitting an award other than an ADT, you must fill out the worksheet completely.

Column A: Overwrite the italicized cells with Course Block TItles (such as Required Courses, Electives). They should match the Course Block Titles on the Course Blocks screen. Enter the units for each Course Block. You can add or remove rows as needed.

Column B: Enter the exact course number and title, as shown on the Course Blocks screen,

Column C: Enter the units for each class.

Column D: Enter the CSU GE-Breadth Area (letter and number) if applicable. Only enter areas that are approved and appear on ASSIST.​

Column E: Enter the IGETC Area (number and letter) if applicable. Only enter areas that are approved and appear on ASSIST.​

Required Major Total: Enter the minimum and maximum total units in the major (not counting GE). If the units do not vary, enter the same number in both cells.

​Completion of CSU-GE Breadth or IGETC pattern: These fields are filled out; do not alter them.

Possible double-counting: Calculate the minimum and maximum number of units in the major that can also count for CSU GEB and IGETC.

Double Counting Procedures for GE

Transferable electives (as needed to reach 60 units): This section is auto calculated based on min/max units and double-counted units; do not alter.

Total Units: This is filled out and should not be altered for most degrees. For high-unit majors, you can overwrite 60 and the calculations will adjust accordingly.

Transfer Model Curriculum

An inter-­segmentally developed Transfer Model Curriculum (TMC) defines the major or area of emphasis for all ADT (transfer) degrees. In the implementation process for SB1440 and Education Code section 66746, the ASCCC, in collaboration with the CSU Academic Senate, has developed a Transfer Model Curriculum (TMC) for certain majors that have been identified for students who transfer from a California community college to CSU.

Once a TMC template is finalized, CCC faculty may then develop degrees that align with the TMC. The designators for these aligned TMC degrees are:

  • Associate in Arts for Transfer (A.A.-­T)
  • Associate in Science for Transfer (A.S.-­T).

If you are submitting an ADT, attach the completed TMC template and any additional transfer documentation as specified on the template.

Transfer Prep for Traditional Associate Degrees

For traditional (non-ADT) Associate degrees, colleges should demonstrate, to extent possible:

  • ​Courses will not only transfer, but specifically towards completion of a major after transfer
  • ​Courses offered in lower division will not have to be repeated in upper division
  • ​All major requirements usually fulfilled in lower division can be filled at the CCC

Specifically, documentation could include:

  • ​ASSIST documentation –major articulation for majority of courses
  • Programmatic articulation agreements
  • Table of program requirements from catalog of targeted transfer institution with crosswalk to CCC program requirements
  • Lower division major prep endorsed by professional bodies/program accreditors
  • Formal letters from targeted institution verifying program alignment